Music TrackerMusic Tracker
Measured from 21 released drum & bass tracks

How loud is drum & bass mastered?

Released drum & bass measures a median of −4.3 LUFS over the thirty seconds a store previews, usually the body of the track. Half of the 21 chart tracks we measured fall between −5.4 and −3.9 LUFS there.

−4.3
LUFS · median, preview
21
tracks measured
−5.4 to −3.9
LUFS · middle half
−14 LUFSSpotify playback−5.4 to −3.9where records sit

Is −14 LUFS the right level for drum & bass?

Not for the master. −14 LUFS is where Spotify plays tracks back by default: it turns a louder master down to it and a quieter one up. Spotify measures the whole track, which reads lower than its loud body, so a drum & bass master whose body sits at −4.3 LUFS is turned down by a little less than the 9.7 dB between the two figures. A master made at −14 is played as it is, and on Spotify the two end up level.

A DJ set is not normalised. A file bought from a store or sent as a promo plays at the level it was mastered, unless the DJ trims the gain by hand or lets their software do it. Section against section, a drum & bass master whose body sits at −14 LUFS lands about 9.7 dB under the released records around it.

Spotify’s figures: Loudness normalization, Spotify for Artists

What true peak should a drum & bass master have?

Spotify asks for a true peak below −1 dBTP, and below −2 dBTP for masters louder than −14 LUFS, which a typical drum & bass master is. Lossy encoding adds a little to the peaks, and the headroom is what keeps them from clipping.

The figures on this page are loudness only. The true peak of a thirty second MP3 preview is not the true peak of the master it came from, so we do not publish one.

Spotify’s figures: Loudness normalization, Spotify for Artists

How much bass does drum & bass have?

Released drum & bass puts a median 57.7% of its power below 150 Hz and 10.0% above 4 kHz. Half of the 30 tracks measured sit between 50.3% and 68.1% below 150 Hz. That is the least low end of the 29 Beatport charts we measured.

30 tracks a chart, from the thirty second previews of the Beatport chart we import, measured on 1 October 2026 over the loud sections of each preview. It is a share of power, not a loudness: a master can be loud and still carry little of it in the low end.

How were these numbers measured?

21 tracks from Beatport's Drum & Bass charts, each found on Deezer and its thirty second preview measured with ffmpeg's EBU R128 loudness filter (ITU-R BS.1770), on 25 August 2026.

The previews are not loudness normalised: the same track read from Deezer and from iTunes agreed within half a decibel. Which thirty seconds a store picks differs, so a single track carries a decibel or two of noise; the median and the middle half across all of them is what we report, never one reading.

A preview usually comes from the body of a track rather than its intro or ending, so these figures describe the part that plays at full level, not the whole file. Measured end to end, a master with an intro and a breakdown reads lower. Compare them with the loud sections of your own track, not with one integrated figure for the whole file.

Drum & Bass next to the genres around it

Drum & Bass
−4.3 LUFS
Dubstep
−4.5 LUFS
Trap / Future Bass
−6.1 LUFS

Median and middle half of each genre, 15 measured in all (the full table). Free to reuse with credit to musictracker.io, under CC BY 4.0.

Where does your drum & bass master sit?

The Demo Analyzer measures the loud sections of your file, its true peak and its dynamics, places the loud sections against this range, then says what is worth fixing before you send it. A free account gets 2 analyses a week.