Music TrackerMusic Tracker
Measured from 25 released techno tracks

How loud is techno mastered?

Released techno measures a median of −6.8 LUFS over the thirty seconds a store previews, usually the body of the track. Half of the 25 chart tracks we measured fall between −7.7 and −5.9 LUFS there.

−6.8
LUFS · median, preview
25
tracks measured
−7.7 to −5.9
LUFS · middle half
−14 LUFSSpotify playback−7.7 to −5.9where records sit

Is −14 LUFS the right level for techno?

Not for the master. −14 LUFS is where Spotify plays tracks back by default: it turns a louder master down to it and a quieter one up. Spotify measures the whole track, which reads lower than its loud body, so a techno master whose body sits at −6.8 LUFS is turned down by a little less than the 7.2 dB between the two figures. A master made at −14 is played as it is, and on Spotify the two end up level.

A DJ set is not normalised. A file bought from a store or sent as a promo plays at the level it was mastered, unless the DJ trims the gain by hand or lets their software do it. Section against section, a techno master whose body sits at −14 LUFS lands about 7.2 dB under the released records around it.

Spotify’s figures: Loudness normalization, Spotify for Artists

What true peak should a techno master have?

Spotify asks for a true peak below −1 dBTP, and below −2 dBTP for masters louder than −14 LUFS, which a typical techno master is. Lossy encoding adds a little to the peaks, and the headroom is what keeps them from clipping.

The figures on this page are loudness only. The true peak of a thirty second MP3 preview is not the true peak of the master it came from, so we do not publish one.

Spotify’s figures: Loudness normalization, Spotify for Artists

How much bass does techno have?

It depends on the style. Of the 3 techno charts measured, Techno (Raw / Deep / Hypnotic) puts the most of its power below 150 Hz, a median 80.3%, and Hard Techno the least, 62.1%.

30 tracks a chart, from the thirty second previews of the Beatport charts we import, measured on 1 October 2026 over the loud sections of each preview. It is a share of power, not a loudness: a master can be loud and still carry little of it in the low end.

How were these numbers measured?

25 tracks from Beatport's Techno (Peak Time / Driving), Techno (Raw / Deep / Hypnotic) and Hard Techno charts, each found on Deezer and its thirty second preview measured with ffmpeg's EBU R128 loudness filter (ITU-R BS.1770), on 25 August 2026.

The previews are not loudness normalised: the same track read from Deezer and from iTunes agreed within half a decibel. Which thirty seconds a store picks differs, so a single track carries a decibel or two of noise; the median and the middle half across all of them is what we report, never one reading.

A preview usually comes from the body of a track rather than its intro or ending, so these figures describe the part that plays at full level, not the whole file. Measured end to end, a master with an intro and a breakdown reads lower. Compare them with the loud sections of your own track, not with one integrated figure for the whole file.

Low end and top, style by style

Style
Below 150 Hz
Above 4 kHz
Techno (Raw / Deep / Hypnotic)
80.3%
2.4%
Techno (Peak Time / Driving)
70.5%
3.9%
Hard Techno
62.1%
6.9%

Median share of a track’s power over the loud sections of its preview, 30 tracks a chart, measured on 1 October 2026.

Techno next to the genres around it

Dubstep
−4.5 LUFS
Trap / Future Bass
−6.1 LUFS
Techno
−6.8 LUFS
Hard Dance / Hardcore / Neo Rave
−6.9 LUFS
Trance
−7.5 LUFS

Median and middle half of each genre, 15 measured in all (the full table). Free to reuse with credit to musictracker.io, under CC BY 4.0.

Where does your techno master sit?

The Demo Analyzer measures the loud sections of your file, its true peak and its dynamics, places the loud sections against this range, then says what is worth fixing before you send it. A free account gets 2 analyses a week.